Publicidad
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
Opt Wakeup
When an audio signal is input through the OPTICAL terminal
while this unit is in standby, this feature automatically detects it.
"On ": This unit is turned on and outputs the audio.
"Off (default value)": The function is disabled.
0 When a cable is connected to the OPTICAL terminal and this
setting is enabled, power consumption increases even when
the unit is on standby, however, the increase in power
consumption is kept to a minimum by automatically entering
the HYBRID STANDBY mode, where only essential circuits
are operating.
AM Freq
Select a frequency step depending on your area of residence.
Select "9 kHz (default value)" or "10 kHz".
0 When this setting is changed, all radio presets are deleted.
4. Source
Vol Abs
Adjust the volume level difference between the devices
connected to the unit. Select the input selector to configure.
Select from "-12 dB" to "+12 dB". Set a negative (j) value if the
volume of the target device is larger than the others and a
positive (i) value if smaller. To check the audio, start playback of
the connected device. (Default Value is "0.0 dB")
Name Edit
Set an easy name to each input. The set name will be shown on
the main unit display. Select the input selector to configure.
For details on how to enter text, refer to "Entering text" (P14).
0 To name a preset radio station, press TUNER on the remote
controller, select AM/FM and select the preset number.
0 It cannot be set if the "NET" or "BLUETOOTH" input is
selected.
> Install
> Initial Setup
> Playback
Supplementary information |
5. Network
0 When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. Further, to assign fixed IP addresses to each component, you must set
"DHCP" to "Disable" and assign an address to this unit in "IP Address" as well as set
information related to your LAN, such as Subnet Mask and Gateway.
Wi-Fi
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off (default value)": To connect via wired LAN
Wi-Fi Setup
You can configure wireless LAN settings by pressing ENTER
when "Start" is displayed.
0 This is displayed only when "On" is selected in "Wi-Fi".
0 Refer to Initial Setup (P12) for Wi-Fi settings.
SSID
The SSID of the connected access point
Signal
The signal strength of the connected access point
Stat
The status of the connected access point
MAC Address
This is the MAC address of this unit.
This value is specific to the component and cannot be changed.
DHCP
"Enable (default value)": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
If "Disable" is selected, you must set "IP Address", "Subnet
Mask", "Gateway", and "DNS Server" manually.
IP Address
Displays/Sets the IP address.
Subnet Mask
Displays/Sets the subnet mask.
Gateway
Displays/Sets the gateway.
DNS Server
Displays/Sets the primary DNS server.
Proxy URL
Displays/Sets the proxy server URL.
Proxy Port
Displays/Sets the proxy server port number when you enter
"Proxy URL".
Advanced Setup
| Others
En
29
Publicidad
