Sharp LL-T15G3 Manual De Funcionamiento página 19

WHITE BALANCE Menu
WHITE BALANCE
COOL STD WARM USER
R-CONTRAST
G-CONTRAST
B-CONTRAST
1024x768
V : 6 0Hz H : 4 8.4kHz
Notes:
- On settings other than [STD] not all graduations
can be displayed. To display all graduations, set
to [STD].
- If COLOR MODE is set to [sRGB] or [VIVID], no
other setting than [STD] can be selected.
- Use the buttons to select [COOL], [·], [STD],
[·], [WARM] or [USER].
- Selecting USER will display the setting values for
[R-CONTRAST], [G-CONTRAST] and [B-
CONTRAST], in order to make fine adjustments.
- Use the / MODE button to select
[R-CONTRAST], [G-CONTRAST] and
[B-CONTRAST].
- To go to the next menu: MENU button
COOL ....... Color tone bluer than standard
• ............. Color tone slightly bluer than standard
STD .......... Color tone standard setting
• ............. Color tone slightly redder than standard
WARM ...... Color tone redder than standard
USER
R-CONTRAST .....
G-CONTRAST .....
B-CONTRAST .....
Adjusting the screen display
button for blue-green
button for red
button for purple
button for green
button for yellow
button for blue
MODE SELECT Menu
MODE SELECT
OSD H-POSITION
OSD V-POSITION
SCALING
COLORS
LANGUAGE
1024x768
V : 6 0Hz H : 4 8.4kHz
Notes:
- Depending on the resolution of the input signal,
even if menu options can be selected, the display
may not change.
- To choose a menu option:
- When adjustment complete: MENU button
OSD H-POSITION (OSD horizontal position)
The position of the OSD display can be moved to
the left and right. (
OSD V-POSITION (OSD vertical position)
The position of the OSD display can be moved up
and down. ( buttons)
SCALING (Level of scaling)
When the display is enlarged, the sharpness of the
image can be set. (
Note:
- When the display mode is set to less than
1024 x 768 pixels, the display is enlarged to
cover the whole screen (i.e. the side ratio of the
display may change).
COLORS
Maximum display colors can be set. (
260K (approx. 260,000) and 16M (approx. 16.19
million)
LANGUAGE
You can chose the language used in OSD Menu.
1. Press the button.
The Language Selection Menu will be displayed
on the screen.
2. Use the / MODE button to choose a language.
3. Press the MENU button.
Language Selection Menu will disappear.
19
LOW HIGH
260K 16M
/ MODE button
buttons)
buttons)
buttons)