YATO YT-82812 Manual Del Usuario página 21

GB
there is a danger of electrolyte leakage. In case of leakage, it is required protect the leakage with neutralizing agent. In case of
contact of electrolyte with the eyes, it is required to rinse the eyes abundantly, and then immediately seek medical assistance. It
is prohibited to use a tool with a damaged battery.
In case the battery is completely worn out, it is required to deposit it at a special point dedicated to disposal of such waste.
Transport of the batteries
Lithium-ion batteries are in accordance with legal regulations treated as dangerous waste. The user of the tool may transport the
tool with the battery or only batteries by land. Then no additional conditions must be complied with. In transport is realised by third
parties (for example dispatch through courier service), then it is required to proceed in accordance with regulations for transport
of dangerous materials. Before shipment, contact an authorised person.
It is prohibited to transport damaged batteries. During transport the battery must be removed from the tool, and the exposed
contacts protected, e.g. with insulating tape. Protect the batteries so that they do not move inside the package during transport. It
is also required comply with the national regulations for transport of dangerous materials.
Charging the battery
Attention! Before charging you should disconnect the charger from the mains by unplugging the power supply plug from the mains.
In addition, you should clean the battery and its terminals of dirt and dust with a soft, dry cloth.
The battery has a built-in charge indicator. When you press the button, LEDs will light up (XVI), the more LEDs will light up, the
more fully the battery pack is charged. If the button is pressed and the LEDs are off it means that the battery is discharged.
Disconnect the battery from the tool.
Push the battery in the charger socket (XVI).
Plug the charger into a mains socket.
When the red LED lights up, it means the loading process.
When charging is complete, the red LED goes off , and green LED lights up, indicating a full charge of the battery.
Unplug the charger from the mains outlet.
Remove the battery from the charging station, by pressing the battery latch button.
Attention! If, when the charger is connected to the power supply, the green LED is on, this indicates a fully charged battery. In this
case, the charger does not start charging.
MAINTENANCE AND STORAGE OF THE PRODUCT
Attention! Before starting any operation, which is described below, you should disconnect the chain saw from the power supply.
Chain saw, which are mains powered, should be disconnected from the wall outlet, the chain saw, which are battery operated,
should be disconnect from the battery.
After each use, you should examine the chain saw condition, with a focus on the patency of ventilation openings.
Check the alignment of all elements of the chain saw. Any loose connections should be tightened. Check the voltage and condition
of the chain. If you notice any chain damage, the chain should be replaced with a new one. It is forbidden to operate the chain
saw with a damaged chain.
Too loose chain may fall out from its guide, which can cause injury to a person that operates the chain saw. The chain must also
be properly sharpened, because it requires the relevant experience and tools, it is recommended, to perform chain sharpening
in a specialist service. You should fi ll up the oil defi ciencies in the tank. The chain saw housing should be cleaned with a soft dry
cloth. Clean the housing of residual wood, oil, grease and other contaminants. The chain saw should be stored in a dry, closed
room, disconnected from the mains.
Attention! During storage, the chain saw may produce a small amount of oil from the chain lubrication system, this is normal and
does not aff ect the oil level in the tank and is not a sign of failure.
The chain saw should be stored in the areas, which are shaded dry, and equipped with adequate ventilation to prevent conden-
sation. The place should not be available for bystanders, especially children. During storage the guide and chain should always
be protected by the cover.
O R I G I N A L I N S T R U C T I O N S
21