OPERATING INSTRUCTIONS
WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc. can cause a
short circuit.
WARNING
parts could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
parts.
This brushless random orbital sander must be used only with the battery packs and
chargers listed below:
2Ah
2Ah
SKIL
SKIL
BY519701
BY519702
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
To Attach/Detach Battery Pack
To attach the battery pack: Align the raised rib on the battery pack with the grooves on the
tool, and then slide the battery pack onto the tool (Fig. 2).
To detach the battery pack: Depress the battery-release button, located on the front of the
battery pack, to release the battery pack. Pull the battery pack out and remove it from the
tool (Fig. 3).
Fig. 2
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
WARNING
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or modification
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
Battery Pack
2.5Ah
SKIL
BY519703
Always switch off the tool before attaching or detaching of the
battery pack.
4Ah
5Ah
SKIL
SKIL
BY519601
BY519603
Fig. 3
Charger
SKIL
SC535801
1
SKIL
QC536001
2
11