Publicidad
Idiomas disponibles
Idiomas disponibles
Follow all charging instructions and do not charge the battery pack or tool outside the
temperature range specified in the instructions. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Never service damaged battery packs. Service of battery packs should only be performed
by the manufacturer or authorized service providers
ADDITIONAL SAFETY WARNINGS
Use clamps or other practical way to secure and support the workpiece to a stable
platform. Holding the work by hand or against your body is unstable and may lead to loss of
control.
Your tool is equipped with a dust canister, empty it frequently, after completion of
sanding and before storing the sander. Be extremely careful of dust disposal, materials in
fine particle form may be explosive. Do not throw sanding dust on an open fire. Combustion
from mixture of varnishes, lacquers, polyurethane, oil or water with dust particles can occur if
there is a static discharge, spark introduced in the box, or excessive heat.
Always wear eye protection and a dust mask for dusty applications and when sanding
overhead. Sanding particles can be absorbed by your eyes and inhaled easily and may cause
health complications.
Do not wet sand with this sander. Liquids entering the motor housing is an electrical shock
hazard.
Do not use sandpaper intended for larger sanding pads. Larger sandpaper will extend
beyond the sanding pad causing snagging, tearing of the paper or kick-back. Extra paper
extending beyond the sanding pad can also cause serious lacerations.
Keep handles dry, clean and free from oil and grease. Slippery hands cannot safely control
the power tool.
Develop a periodic maintenance schedule for your tool. When cleaning a tool be careful
not to disassemble any portion of the tool since internal wires may be misplaced or
pinched or safety guard return springs may be improperly mounted. Certain cleaning
agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts.
5
Publicidad
