Hart HGCS02 20V Manual Del Operador página 29

MAINTENANCE
 Wear inside the bar rails that permits the chain
to lay over sideways
 Bent guide bar
 Cracked or broken rails
 Spread rails
TRANSPORTING AND STORING
See Figure 41.
WARNING:
Always remove the battery pack before trans-
porting or storing chain saw. Place battery pack
indoors in a dry, secure location out of the reach
of children when storing. Failure to follow these
instructions may lead to accidental starting or
unauthorized use and result in serious personal
injury.
BAR AND CHAIN COMBINATIONS
Chain specifications: 3/8 in. pitch, standard, 0.043 in. chain gauge, 6-tooth drive sprocket.
Length of Bar
12 in.
TROUBLESHOOTING
PROBLEM
Bar and chain
running hot and
smoking.
Motor runs,
but chain is not
rotating.
Guide Bar Part Number
316751001
CAUSE
Check chain tension
for overtightened
c ondition
Chain oil tank empty.
Chain tension too
tight.
Check guide bar and
chain assembly.
Check guide bar and
chain for damage.
 Do not store or transport the chain saw when
it is running. The chain saw should always be
idle before storing or transporting.
 Always place the guide bar scabbard on the
bar and chain before storing or transporting the
chain saw. Use caution to avoid the sharp teeth
of the chain.
 Clean the chain saw thoroughly before storing.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.
 Keep away from corrosive agents such as gar-
den chemicals and de-icing salts.
Chain Part Number
678928001
SOLUTION
Tension chain. Refer to Adjusting Chain Tension earlier
in this manual.
Check oil tank.
Retension chain. Refer to Adjusting Chain Tension
earlier in this manual.
Refer to Replacing Bar and Chain earlier in this
manual.
Inspect guide bar and chain for damage.
29 – English
Drive Links
45