Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting (Tower)
Warning: When mounting the UPS system in a tower orientation, make sure the LCD
Screen panel is at the top of the UPS, not at the bottom.
Note: To mount the UPS in an upright (tower)
position, 2-9USTAND is required (sold separately).
Rotate the LCD Screen panel for easy viewing
while the UPS is tower mounted. Insert a small
screwdriver or other tool in the slots on either
side of the panel. Pop the panel out, rotate it
and pop the panel back in place.
Optional Installation
These connections are optional. The UPS will function properly without these connections.
USB and RS-232 Serial
1
Communications
Use the included USB cable (see
DB9 serial cable (see
communication port on the computer to the
communication port of the UPS. Install the
appropriate Tripp Lite PowerAlert
to the computer's operating system.
EPO Port Connection
2
This optional feature is only for those
applications which require connection to a
facility's Emergency Power Off (EPO) circuit.
When the UPS is connected to this circuit, it
enables emergency shutdown of the UPS
inverter.
Using the cable provided, connect the EPO
port of the UPS (see
normally closed or normally open switch
according to the circuit diagram (see
The EPO port is not a phone line surge
protector; do not connect a phone line to
this port.
18-01-271-933440.indb 7
) or
1A
) to connect the
1B
Software
®
) to a user-supplied
2A
).
2B
7
1A
1B
2A
2B
4-5
1/25/2018 3:23:21 PM
Publicidad
