Beurer EM 37 Instrucciones Para El Uso página 13

Description of the display symbols
A Key key lock is activated
B Pause symbol flashes if pause is activated
C Battery status flashes if the battery is flat
display
D Intensity set intensity levels 0 - 40
E Program selected program with the number
of training cycles already com-
pleted
F Timer remaining time for the program
started
5. Operation
Inserting batteries
If the battery symbol in the display flashes, the batteries are flat and must be replaced.
The operating unit must be removed from the holder on the belt to insert or replace bat-
teries.
― Pull the device upwards out of the holder.
― Remove the battery compartment lid.
― Insert the batteries observing the markings in the battery compartment. Ensure correct
battery polarity.
Note:
― Rechargeable batteries cannot be used for this device.
― If the device is not in use, we recommend keeping the device separate from the belt. If
the device is not needed for a long period, we recommend first removing the batteries.
― The empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the batteries.
― The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
― For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the de-
vice in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you
have any questions, please contact the local authorities responsible for waste disposal.
Attaching the belt
Before each training session you should ensure that your skin is clean and free of creams or oils. Only
then can the device work optimally.
― Lay the belt down with the electrodes facing towards you.
― Moisten the electrodes and your stomach with water. Ensure that the surface of the electrodes is evenly
moistened to avoid isolated spikes in voltage on your skin when training later.
― Place the belt around your waist so that the electrodes are positioned on your stomach. Then close the
Velcro fastener.
Take care that it is tight enough for good contact between the electrode and skin, but does not constrict
you.
If the belt is not big enough for your waist measurement, the supplied belt extension can be used.
A
88
P
D
88 8-88 88
P
Das digital-ABC:
ABCDEFGHIJKLMNOPQRSTUVWXYZ
13
B C
88
8-88
E F