Publicidad
Idiomas disponibles
Idiomas disponibles
Squeegee not cleaning or vacuum weak.
Battery not giving expected operational
endurance.
Red Led alight on brush control button,
1 fast blink.
Red Led alight on brush control button,
2 fast blinks.
Red Led alight on suction control button,
1 fast blink.
Green battery charge Led blinking.
sequence.
simultaneously.
"buzzer beep" when the brush control
lever is pressed.
The edge of the squeegee rubber
tripped (dirty water tank full).
Squeegee suction hose clogged.
The suction hose is not connected to
the squeegee or is damaged.
Diverter valve dirty.
The battery charger is not working.
ALARMS
Brush motor overcurrent/short circuit.
Detergent
pump
overcurrent/short
circuit.
Suction motor overcurrent/short circuit.
Excess battery voltage.
Battery charging.
No
communication
between
control card and touch card.
Machine position incorrect.
EN
Replace the rubber blades.
Empty the dirty water tank.
Unclog the hose.
Connect or repair the hose.
Clean diverter valve.
Replace battery charger.
Restart the machine.
If the alarm appears again, make certain
that the brush is not being used on a
If the problem persists, contact customer
service.
Restart the machine.
If the problem persists, contact customer
service.
Restart the machine.
If the problem persists, contact customer
service.
Check the integrity, operation and use
of the battery charger supplied with the
machine. Wait 10 minutes then try again.
Remove the charging connector from the
battery.
power
Wiring or card problem. Contact service.
Make sure the machine is horizontal.
25
Publicidad
