Kenmore BC4002 Manual De Uso Y Cuidado página 10

1. Pull cord out of canister to desired length.
The cord will not rewind until the cord rewind
button is pushed.
2. Plug the polarized power cord into a 120
Volt outlet located near the floor.
To rewind: Turn off and unplug the vacuum
cleaner. Hold the plug while rewinding to
prevent damage or injury from the moving
cord. Push cord rewind button.
3. Lower the wand from upright position by
pressing on the HANDLE RELEASE pedal.
Handle
Release
4. Select a pile height setting by pressing
the height adjustment pedal on the rear of
the PowerMate
shows on the indicator.
Height
Adjustment
Pedal
5. Push the power switch on the canister
body to turn the vacuum suction ON or OFF.
To turn on the PowerMate
the handle switch to the CARPET position.
The PowerMate
To use the canister motor only, slide the
handle switch to the FLOOR position. The
PowerMate
®
Agitator On
- 10 -
® . The pile height setting
Height
Adjustment Indicator
motor, slide
®
agitator will start to spin.
®
agitator will stop spinning.
Agitator OFF