Descargar Imprimir esta página

Progress Lighting P250017 Manual De Instalación página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Fan will not start
1. Check circuit fuses or breakers.
2. Check line wire connections to the fan and switch wire connections in the switch housing.
3. Check to make sure the dip switches from the transmitter and receiver are set to the same frequency.
4. Check to make sure the control is within 30 feet from the fan.
5. Check to see if the control is in a metal switch box. A metal switch box could cause interference with the control signal
Fan sounds noisy.
1. Make sure all motor housing screws are snug.
2. Make sure the screws that attach the fan blade bracket to the motor hub is tight.
3. Make sure wire nut connections are not rubbing against each other or the interior wall of the switch housing.
4. Allow a 24-hour "breaking-in" period. Most noise associated with a new fan disappear during this time.
5. Some fan motors are sensitive to signals from solid-state variable speed controls. If you have installed this type of control,
6. Make sure the upper canopy is a short distance from the ceiling. It should not touch the ceiling.
Remote Control
1. Do not connect the fan with wall mounted variable speed control (s).
Malfunction.
2. Make sure the dip switches are set correctly
15. Troubleshooting
Solution
CAUTION: Make sure main power is off.
and result in the fan not being able to respond to the desired switch commands.
CAUTION: Make sure main power is off.
choose and install another type of control.

Publicidad

loading