Publicidad
Idiomas disponibles
Idiomas disponibles
Make the Electric Connections
WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
Note: The control should be within 30 feet from the fan. Installing the switch in a metal switch box could cause intereference with the control
signal and cause the fan not to respond as desired to the switch commands.
If you feel you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
1. Disconnect the power and remove the existing wall plate and switch from the wall outlet box.
2. Make wire connections as follows, using the wire nuts. (Fig. 8)
a. Wall control wire connection. (Fig. 8)
CONNECT
(From wall control)
Black wire (TO MOTOR L)
Black wire (AC IN L)
Yellow/green ground wire
• If your wall outlet box has a ground wire (green or bare copper), connect the wall control's yellow/green ground wire to it; otherwise connect the
wall control's yellow/green ground wire directly to one of the screws from the wall outlet box.
b. Fan wire connection. (Fig. 8)
CONNECT
(From fan)
Black fan wire
White wire
Green wire
5.
TO
(From wall outlet box)
White wire
Black wire from wall control's
Outlet box green wire
TO
(Conductor cable between ceiling and wall outlet box)
White wire
White wire from A/C supply source
Ground conductor of 120V supply, it may be a bare wire
or a wire with green colored insulation.
Publicidad
