EINHELL GC-GP 8042 ECO Manual De Instrucciones página 16

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Danger!
In stagnant water bodies, garden ponds,
swimming ponds and their surrounding are-
as the unit may only be used with an earth-
leakage circuit breaker with an actuating ra-
ted current of up to 30 mA (according to VDE
0100 Part 702 and 738).
The equipment is not designed for use in
swimming pools and paddling pools of any
kind or other bodies of water in which people
or animals may be present during operation.
It is prohibited to operate the equipment if a
person or animal is in the danger area. Ask
your electrician!
Danger!
•
Always inspect the equipment visually before
using it. Do not use the equipment if safety
devices are damaged or worn. Never disable
safety devices.
•
Use the equipment only for the purposes indi-
cated in these operating instructions.
•
You are responsible for safety in the work
area.
•
If the cable or plug is damaged by external in-
fluences, the cable may not be repaired. The
cable must be replaced by a new one. This
work may only be carried out by a trained
electrician.
Anl_GC_GP_8042_ECO_SPK9.indb 16 Anl_GC_GP_8042_ECO_SPK9.indb 16
GB
•
The voltage of 220-240 V alternating voltage
specified on the rating plate must be the
same as the mains voltage.
•
Never use the power cable to lift, transport or
secure the equipment.
•
Ensure that the electrical plug connections
are in areas that are not at risk of flooding or
protect them from moisture.
•
Pull the mains plug before starting any work
on the equipment.
•
Do not expose the equipment to a direct jet of
water.
•
The operator is responsible for complying
with local safety and installation regulations.
(Ask an electrician if you are in any doubt.)
•
Consequential damage caused by flooded
rooms in the event of the equipment suffering
faults must be prevented by the user by me-
ans of suitable measures (for example instal-
ling alarm systems or a reserve pump, etc.).
•
In the event of a failure, repair work may only
be carried out by an electrician or by ISC after
sales service personnel.
•
The equipment must never run dry or be
used when the intake line is closed fully. The
manufacturer's warranty does not cover da-
mage caused to the equipment as a result of
running it dry.
•
The pump must not be used to operate swim-
ming pools.
•
The equipment must not be installed in the
drinking water pipe line.
2. Layout and items supplied
2.1 Layout
1. Filling level indicator
2. Suction connection
3. Water fi ller screw
4. Pressure connection
5. Carry handle
6. Power switch
7. Water drain screw
8. Connection adapter approx. 33.3 mm
(R1 male thread)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
- 16 -
12.05.2020 11:38:12 12.05.2020 11:38:12