Publicidad
ASSEMBLY OF THE
CROSSBASE AND
THE COLUMNS
PG
IMPORTANT:
Install in the following order:
• Take one crossbar type Part E and fix it to the PG crossbar with the TV screws.
• Lastly, place the other PG crossbar with the previously installed column PV1335.
PG
TM640
x2
NOTE: there is only one crossbar
between the PG crossbars (Part E)
To assemble part PG with part E:
Make the two holes situated at
the end of part PG coincide with
those situated inside (second
line) of part E.
AP
Place the flap AP so that it
coincides with its two holes with
those of the PEU part (the closest
to the part PV1335). Then, place
the other AP flap and fix them
with two bolts TM640 (place the
AP flaps after having introduced
the support into the previously
prepared ditch).
57
Ref. KPBOC5352
*
E
Publicidad
