Publicidad
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2-f3-f4)
To install the rivet, hold the riveting button D (f1) down for
at least 0.5 seconds. In the event of a continuous use of the
tool, be sure to let it cool down completely every two battery
replacements.
f1
D
WARNING!
Keep truncated stems in a specific container.
Dispose of stems properly.
DISPLAY
This riveting tool has a display F (f2) ) with the following
functions:
G - battery charger (b).
H - cycle counter (c).
I - totalizer (t).
The display F turns on by pressing the riveting button D (f1).
Press (
) to shift from one function to another.
BATTERY LEVEL
This riveting tool has a display, which indicates the battery
charge level.
L - Maximum battery level (Hi).
M - Minimum battery level (Lo).
The display turns on by pressing the riveting button D (f1).
Replace and charge the battery when it reaches its minimum
level M (f2).
Warning: to increase the battery life, prevent it from flattening
completely.
CYCLE COUNTER
This machine is equipped with a cycle counter and a totalizer,
which are viewed through the display F (f2).
Press (
) to shift from one function to another.
18
GB
The cycle counter is useful for the following:
- knowing the average durability of the clamps and programming
their cleaning
- verifying how many rivets are installed during the work cycle
- etc
The cycle counter can display 6 numbers MAX, displayable in
three groups of two figures.
Example: Read 45 cycles
STEP 1
Press (
) holding it down for 3 seconds to reset the cycle
counter.
The totalizer measures the entire lifespan of the riveting tool
and cannot be reset.
f2
F
G
H
Date 05-2017
STEP 2
STEP 3
I
M
L
Revision - 02
EB 400
Publicidad
