Publicidad
Idiomas disponibles
Idiomas disponibles
Use
Fitting a socket
WARNING! RISK OF INJURY!
►
Disconnect the compressed air supply before
working on the tool .
♦
Push one of the supplied sockets 6 and/or the
extension attachment 7 onto the square socket
bit holder 1 .
Switching on/off
Switching on
♦
Press the trigger 5 to switch the tool on .
Switching off
♦
Release the trigger 5 .
♦
When you have finished working, disconnect
the tool from the compressed air source .
Setting the torque
♦
Press the torque control 4 and set the desired
torque range by turning it . Click the desired
level into place at the ◄ marker .
NOTE
►
The torques which can be achieved depend
on the compressed air system installed .
Setting Torque
1
weak/minimum
2
normal
3
strong
4
very strong/maximum
PDSS 310 B5
Changing the direction of rotation
WARNING!
►
The rotation direction switch 2 may only be
used/adjusted when the tool is at a standstill .
♦
Press the rotation direction switch 2 in the
direction "F" (Fasten) to set the clockwise rotation
mode . You can use this mode to tighten nuts, for
example .
♦
Press the rotation direction switch 2 in the
direction "R" (Release) to set the anticlockwise
rotation mode . You can use this mode to un
fasten nuts, for example .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed air supply.
CAUTION!
►
Before carrying out maintenance, clean off
any hazardous substances that may (due to
working processes) have accumulated on
the tool . Avoid all skin contact with these
substances . If the skin comes into contact
with hazardous dusts, this can lead to severe
dermatitis . If dust is produced or swirled up
during maintenance, it can be inhaled .
NOTE
►
To ensure correct functioning and longterm
durability of the tool, pay attention to the
following points:
■
Sufficient and continuous oil lubrication is highly
important for optimum functionality .
■
Check the speed and vibration levels after each
use .
■
If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and dealt with .
GB │ MT
│
59
■
Publicidad
