GE ASD06 Serie Manual Del Propietario E Instrucciones De Instalación página 13

Window Installation Instructions
6 INSTALL THE CASE
IN THE WINDOW
Cut the window sash seal to the window
A
width and stick the adhesive side to the
bottom of the sash.
Window sill
Window sash seal
B
Thread two type C bolts into the support
brackets.
Slide the case into the window and lower
the window behind the top mounting rail.
Position the brackets on the case bottom so
they will be near the outermost point on the
window sill. Attach the support brackets to
each side of the case bottom using 4 type A
screws on each side. Adjust the leveling
bolts to touch the sill.
Window sill
CAUTION:
bolts do not contact the window sill,
or if you have a window without a sill,
you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit ge.com.
Type A screws
Type C bolts
If the sill support
6 INSTALL THE CASE
IN THE WINDOW
Locate the 7 screw holes along the bottom
C
front edge of the case. Center the case, side-
to-side, in the window and mount it to the
window sill using 3 type B screws staggered
in the front and back rows if possible.
Type B
screws
Type B screws
D Extend the left and right accordion panels to
the vertical window sashes and attach with
4 type B screws.
INSTALL THE SECURITY
7
BRACKET AND THE FOAM TOP
WINDOW GASKET
Attach the security bracket with a type B
A
screw.
B Cut the foam top window gasket to the
window width.
C
Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
13
(cont.)
Top mounting rail
Type B
screws