GE ASD06 Serie Manual Del Propietario E Instrucciones De Instalación página 6

About the controls on the air conditioner—models with control knob(s).
Features and appearance may vary.
Controls
ON/OFF Switch
Turns air conditioner on and off.
NOTE: If the air conditioner is off and is then turned on while
set in a Cool mode, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Fan Switch
Use to set the fan speed to LO or HI .
Mode/Temp Control
Use to set the air conditioner to the Fan Only or a
Cool mode.
Fan Only Mode
Use Fan Only at HI or LO Fan to provide air
circulation and filtering without cooling.
Cool Mode
Use a Cool setting with HI or LO Fan for cooling.
Turn the knob clockwise, toward the larger blue
area, for the indoor area to become cooler. Turn
the knob counterclockwise, toward the smaller blue
Controls
Mode Control
Hi Cool, Med Cool and Low Cool provide cooling
with different fan speeds.
Low Fan or Hi Fan provides air circulation and
filtering without cooling.
Thermostat Control
The thermostat control is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the same level of
comfort. When you turn the knob to a higher
number, the indoor air will become cooler. Turn
the knob to a lower number and the indoor air
6
will become warmer.
(on models so equipped)
(on some models)
(on models so equipped)
area, for the indoor air to become warmer.
The Mode/Temp control is used to maintain the
room temperature. When set in a Cool mode, the
compressor will cycle on and off to keep the room
at the same level of comfort.
Cooling Descriptions
For Normal Cooling— Select a Cool mode with the
Mode/Temp knob set at the midpoint.
For Maximum Cooling— Select a Cool mode with
the Mode/Temp knob set toward the larger
blue area.
For Quieter & Nighttime Cooling— Select a Cool mode with
the Mode/Temp knob set toward the smaller blue area.
NOTE: If you move the Mode/Temp control knob from a
Cool setting to the Fan On setting, wait at least 3 minutes
before switching back to a Cool setting.
NOTE: If you move the switch from a cool setting to OFF or
to a fan setting, wait at least 3 minutes before switching back to a
cool setting.
Cooling Descriptions
For Normal Cooling –Select Hi Cool or Med Cool with the
thermostat control at midpoint.
For Maximum Cooling –Select Hi Cool with the thermostat
control at the highest number available on your knob.
For Quieter & Nighttime Cooling –Select Low Cool with the
thermostat control at midpoint.