Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
1. Never mix gasoline and oil directly in the Hedge Trimmer fuel tank.
CAUTION!
1. Do not use National Marine Manufacturerʼs Association (NMMA) or BIA certified oils. This type
or two-stroke engine oil does not have the proper additives for air-cooled, two-stroke engines
and can cause engine damages.
2. Do not use automotive motor oil. This type of oil does not have the proper additives for air-
cooled, two-stroke engines and can cause engine damage.
ADJUSTING THE CUTTING BLADES
CAUTION-DO NOT TOUCH THE SHARPENED EDGES OF THE CUTTING BLADES. THE
CUTTING BLADES ARE EXTREMELY SHARP AND DANGEROUS AT ALL TIMES. ALWAYS
WEAR GLOVES TO HELP PROTECT YOUR HANDS AND FINGERS FROM INJURY.
Before operating the Hedge Trimmer check the adjustment of the cutting blades. Blades
that are too loose may vibrate and will not provide a clean smooth cut.
CAUTION-BLADES THAT ARE TOO TIGHT CAN CAUSE OVERLOADING
WHICH MAY DAMAGE THE EQUIPMENT.
To adjust the cutting blades, refer to the illustrations and locate the screws.
Loosen the nuts.
Gently turn the screws in until snug, then turn the
screws back out one-fourth to a half. While hold-
ing the screws in place, tighten the nuts. Liberally
coat the cutting blades with light oil. Start the
engine and operate the Hedge Trimmer at full
speed for at least one minute. Stop the engine,
when the blades are motionless, touch the blades
with your hand.
The blades should be warm, if they are too hot to
touch, loosen the screws 1/2 turn.
ROTATIONAL REAR HANDLE (H23DFR, H23DFLR)
Rear handle is adjustable to five different positions by pulling the lock lever and turning the
rear handle. Pull the lock lever directly in line with the handle (following the arrow in fig),
then turn the rear handle.It is extremely important that the handle is completely located
and correctly locked in the selected position.
Do not adjust the rear handle to any other position
than the specified five positions.
(Throttle lever does not work when the rear handle is unlocked)
Stop the engine before changing the rear handle position.
Make sure the rear handle is locked before starting the engine.
During operation, hold the rear handle upright regardless of the
blade direction.
Select the proper handle position to be sure of a safe and
secure operating position.
uPPer blade
lOWer blade
｜ 16 ｜
nuT
guIde bar
WaSHer
SCreW
nuTS
SCreWS
LOCK LEVER
English
Publicidad
