Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING AND STOPPING PROCEDURE
Before Starting The Engine: Fill the fuel tank as instructed in the BEFORE OPERATION section
of this manual. Rest the Hedge Trimmer on the ground. Make sure that the cutting blades are
clear of branches, shrubs, debris, etc. Keep all bystanders, children, and animals away from the
working area.
STARTING THE ENGINE (for the carburetor with primer bulb)
The carburetors on MARUYAMA engines contain a choke system and are designed to start at
IDLE speed.
1. Push and release the fuel primer bulb located on the
bottom of the carburetor until air bubble free fuel is
seen flowing through the clear fuel return hose back to
the fuel tank.
2. Move the choke lever to the closed position "
When the engine is warm, move the choke lever to the
open position "
3. Set the engine stop switch to the "ON ( | )" position.
The throttle trigger positioned at IDLE.
4. Grasp the starter grip, slowly pull the starter cord out
until you feel some resistance, then pull the cord
quickly and powerfully. Pull the starter grip until the
engine starts. After the engine is started, move the
choke lever to the open position.
5. After starting, allow the engine to run a few minutes to
warm it up before using.
Before starting the engine, place the machine on the ground and make sure the blade is
free from branches and stones.
English
."
PrIMer bulb
."
STOP (O) ←→ On ( | )
On ( | ) ←→ STOP (O)
｜ 17 ｜
PuMP
Fuel-reTurne lIne
CHOKe leVer
STOP SWICH
STOP SWICH
Publicidad
