Publicidad
Idiomas disponibles
Idiomas disponibles
12V DC Battery Charger Port - Plug the 120 Volt
12
AC charger into this port to charge the generator
battery.
13
DC Circuit Breaker - The circuit protector may be reset
by pushing the button of the protector.
Parallel Operation Outlets - These outlets are used
14
for connecting two FIRMAN inverter generators for
parallel operation. A FIRMAN parallel kit(optional
equipment) is required for parallel operation.
12V DC outlet – 8.3 Amp of DC current may be drawn
15
from this receptacle.
Use this outlet to charge 12V automotive type
batteries ONLY. See 12V DC outlet (Battery
Charger) section.
Ground Terminal – Consult an electrician for local
16
grounding regulations.
Outlet Cover - Protect the receptacles from dust
17
and debris.
18
Recoil Stater
19
LPG Hose Quick Connect Inlet
Fuel Selector Switch Used to select and turn on
20
gas or LPG fuel source.
Choke Button
21
22
LPG Regulator Solenoid Port
English
-
Battery Cable Connection
Follow below instruction to connect battery to
the generator:
1.Unscrew the maintenance cover by provided
screwdriver.
2. Cut wire tie that is binding the black battery
cables A and B.
3. Insert the male connector of cable A into
female connector of cable B.
4. Reattach the maintenance cover.
Regulator Cover Installation
D
A
Follow below instruction to install the LPG
regulator cover:
1, Place the LPG regulator cover A over the LPG
regulator B.
2, Use M5X14(QTY:3) C and M5X35(QTY:1) D
screws to tighten the LPG regulator cover.
Page 10
C
B
Customer Service: 1-844-FIRMAN1
Publicidad
