Publicidad
ENGLISH
PARTS
1. On/Off switch
2. Zoom wheel
3. Length position indicator
4. Charge indicator
CHARGING YOUR APPLIANCE
Before using your trimmer for the first time, charge for 4 hours.
1. Ensure the product is switched off.
2. Connect the charging adaptor to the product and then to the mains.
3. The charging indicator will illuminate.
•
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
•
To preserve the life of your batteries, let them run out every 6 months then recharge for
4 hours.
•
On a full charge, your beard trimmer will run for up to 50 minutes of cordless usage.
CORDED
•
Connect the appliance to the mains and turn on.
•
We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
FITTING THE ADJUSTABLE COMB
•
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to
keep it from turning. Ensure the length position indicator is at 1.5.
•
Slide the comb down the grooves until it clicks into place.
•
The comb can only be attached one way.
TO THIN AND TAPER THE BEARD/MOUSTACHE
1. Fit the adjustable comb.
2. Use the zoom wheel to set the comb to the desired length setting.
3. The setting will appear on the length position indicator. If you are trimming for the first
time start with the maximum trimming length setting.
4. Turn the unit on.
4
Charge Level
Charging
Fully Charged
5. Trimmer assembly
6. Adjustable comb
7. Adaptor (not shown)
8. Cleaning brush (not shown)
Indicator
LED will show
LED will turn off
Publicidad
