Surtek HL730 Manual De Usuario página 17

it will dischage the water when the system is in
by pass. It is also a features that use for sucking
the water from tank or pool. But it have to be
connect the hose that supply with.
STARTING THE POWER WASHER
Prior to starting, please check the electrial sup-
ply voltage and the frequency correspond to
those specified on the applicance data plated.
1. Make sure the switch of the machine is in the
OFF position.
2. Check the mains power supply should
equipped with an adequate earth connection.
3. Make sure the power cord, hose, any con-
nector and gun is without any damaged.
4. Make sure that the filter screen is in water
inlet of pump.
• Cone side faces out.
5. Turn water source on, and trigger on the
gun to relieve the pressure while starting.
NOTE: must point the gun to a safty direction.
WARNING: FAILURE TO TURN ON THE WA-
TER COULD CAUSE DAMAGE TO THE PUMP.
OPERATION THE UNIT WITHOUT WATER WILL
CAUSE SEALING WEARING OUT IN A MINUTER.
6. Inser the plug or switch the machine in the
ON position to start the machine.
NOTE: If please stop the motor immediately
and check the the electrial supply Voltage and
the Frequency correspond to data plated.
the motor does not start after after switched
on, or the motor start noisy,
7. Pull the trigger on the gun to start water
jetting:
• Stand on a stable surface and grip gun/spray
wand firmly with both hands.
• Expect the gun to kick when the trigger is
pulled.
8. Release trigger to stop water flow.
NOTE: The power washer will automatically go
into bypass mode.
WARNING: DO NOT ALLOW UNIT TO OPER-
ATE IN BYPASS MODE FOR MORE THAN TWO
MINUTES AT ANY TIME. OVERHEATING OF
PUMP CAN CAUSE DAMAGE TO PUMP.
E N G L I S H •
USING THE SPRAY NOZZLE TIPS
Follow these instructions to change spray tips:
1. Engage trigger lock on spray gun.
2. Pull back collar on quick-connect and pull
current spray tip off.
3. Select desired spray tip:
For gentle rinse, select white 40 or green 25
spray tip. To scour surface, select yellow 15 or
red 0 spray tip. To apply chemical, select black
spray tip.
4. Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it
is securely in place.
5. For most effective cleaning, keep spray tip
from 8 to 24 inches away from cleaning sur-
face.
6. DO NOT get closer than 6 inches when clean-
ing automobile tires.
Spray Tips
LOW PRESSURE
to apply detergent
White
40°
Black
SPRAY NOZZLE MAINTENACE
A pulsing sensation felt while squeezing the
spray gun trigger may be caused by excessive
pump pressure. The principal cause of excessive
pump pressure is a nozzle clogged or restricted
with foreign materials, such as dirt, etc. To
correct the problem, immediately clean the
nozzle.
ADJUSTING THE PRESSURE
The pressure setting is preset at the factory. To
lower the pressure:
1. Adjust the pressure regulator on the pump.
Turn the pressure regulator knob counter
clockwise to lower pressure. Once you have
finished using your power washer, return the
pressure regulator to its original position.
2. Back away from the surface to be cleaned.
The further away you are the less the pressure
will be on the surface being cleaned.
3. Adjust the spray to a wider angle.
U se r ' s m an ua l
Green Yellow Red
25° 15° Point Jet
HIGH PRESSURE TIPS
17