Shutting Down - Surtek HL730 Manual De Usuario

APPLYING CHEMICALS AND CLEANING
SOLVENTS
1. Push the chemical
hose onto the barbed
fitting located near
high pressure hose
connection of pump
as shown in figure 11.
2. Place other end of chemical hose with filter
on it into c ontainer holding chemical/cleaning
solution.
• The water/chemical ratio is 7:1, for every 7
gallons of water pumped 1 gallon of chemical/
cleaning solution will be used.
RECOMMENDED CLEANING PROCEDURE
Turn on the water supply tap FULLY. Release
the safety catch, then press the trigger for a
few seconds to allow air to escape and to dis-
charge residual pressure in the pipes.
Dissolve dirt by applying detergent with the
fan jet to the dry surface. On vertical surfaces,
work from the bottom upwards.
Leave the detergent to act for 1 to 2 minutes,
but do not allow to dry out. Apply the high
pressure jet, keeping the nozzle at least 10"
(30 cm) from the surface, working from the
bottom upwards. Avoid allowing the rinsing
water to run on to unwashed surfaces.
WARNING: Always test the spray in an area
free and clear of people and objects before
you sprayat the intended cleaning surface.
WOOD AND VINYL DECKS
Rinse deck and surrounding area with fresh
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. For optimal results, reduce
your work area to smaller sections and clean
each section one at a time. Allow the deter-
gent to rest on the surface for a few minutes
and then rinse at high pressure. DO NOT LET
THE CLEANSER DRY. Always clean from left to
right and top to bottom for best results. Rinse
at high pressure using the fan spray keeping
the tip of the spray nozzle at least 6-9 inches
from the cleaning surface. Maintain a further
distance from the cleaning area when using a
direct spray.
CAUTION: For softer woods, increase the
distance from the cleaning area.
18
CEMENT PATIOS, STONE, AND BRICK
Rinse cleaning and surrounding area with fresh
Fig.11
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. Rinse at high pressure using
the fan spray in a sweeping motion keeping
the tip of the spray nozzle at least 3-6 inches
from the cleaning surface. Maintain a further
distance from the cleaning area when using a
direct spray.
CARS, BOATS, AND MOTORCYCLES
Rinse cleaning and surrounding area with fresh
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. To achieve the best results,
clean one side at a time. Allow the detergent
to rest on the surface for a few minutes, but do
not let the detergent dry. Rinse at high pres-
sure using the fan spray in a sweeping motion
keeping the tip of the spray nozzle at least 8
inches from the cleaning surface. Maintain a
further distance from the cleaning area when
using a direct spray. Wipe surface dry for a
polished finish.
IMPORTANT: Only use liquid detergent, DO
NOT use regular detergent.
BARBECUE GRILLS, POWER EQUIPMENT, AND
GARDEN TOOLS
Rinse cleaning and surrounding area with fresh
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. Allow the detergent to rest
on the surface for a few minutes, but do not
let the detergent dry. Rinse at high pressure
using the fan spray keeping the tip of the spray
nozzle at least 1-3 inches from the cleaning
surface.
Maintain a further distance from the cleaning
area when using a direct spray.

SHUTTING DOWN

1. After each use, if you have applied chemi-
cals, place chemical hose into container of
clean water and run clean water through
chemical injection system to flush the system
thoroughly.
NOTE: Failure to do s o could cause damage to
the pump.
2. Switch the motor in the OFF position, or pull
out the plug to stop the motor.