Moon Phase; Pointing The Wireless 5-In-1 Sensor To South - Explore Scientific WSX1001 Manual De Instrucciones

2. The setting sequence: Time Zone
format Year
Language.
3. Press [ ] or [
4. Press [ CLOCK SET ] key to save and exit the setting mode, or the unit will automatically
exit the setting mode 60 seconds later without pressing any key.
NOTE:
- In normal mode, press [ CLOCK SET ] key to switch between year and date display.
- During the setting, you can press and hold [ CLOCK SET ] key for 2 seconds to back to
normal model.

MOON PHASE

The moon phase is determined by
the time, date and time zone. The
following table explains the moon
phase icons of the Northern and
Southern hemispheres. Please refer
to ORIENTING THE 5-IN-1 SENSOR
TOWARDS SOUTH section about
how to setup for the Southern
hemispheres.

POINTING THE WIRELESS 5-IN-1 SENSOR TO SOUTH

The outdoor 5-IN-1 sensor is calibrated to point to North for the maximum accuracy. However,
for the user's convenience (e.g. users in the Southern hemisphere), it is possible to use the
sensor with the wind vane pointing to South.
1. Install the 5-IN-1 wireless sensor with its wind meter end pointing to South. (Please refer to
INSTALLATION OF THE WIRELESS SENSOR for mounting details)
2. In normal mode of the console, press and hold [ INDEX ] key for 10 seconds to enter into
the calibration mode, then press [ INDEX ] key again until the "N" icon appears on the left
botton corner of the LCD to enter into the sensor orientation mode.
3. Use [ ] or [
4. Press [ INDEX ] key to confirm and exit.
NOTE:
Changing the hemisphere setting will automatically switch the direction of the moon phase on
the display.
Month Day
] key to change the value. Press and hold the key for quick-adjust.
] key to change to lower part (Southern Hemisphere).
DST ON/OFF Hour
M-D/D-M format
Northern
hemisphere
17
Minute 12/24 hour
Time sync ON/OFF
Moon Phase
New Moon
Waxing Crescent
First quarter
Waxing Gibbous
Full Moon
Waning Gibbous
Third quarter
Waning Crescent
weekday
Southern
hemisphere