Setting Alarm Time; Activating Alarm And Temperature Pre-Alarm Function; Temperature / Humidity Function & Trend - Explore Scientific WSX1001 Manual De Instrucciones

SETTING ALARM TIME

1. In normal time mode, press and hold [ ALARM ] key for 2 seconds until the alarm hour digit
flashes to enter alarm time setting mode.
2. Press [ ] or [
3. Press [ ALARM ] key again to step the setting value to Minute with the Minute digit flashing.
4. Press [ ] or [
5. Press [ ALARM ] key to save and exit the setting.
NOTE:
- In alarm mode, the "
- The alarm function will turn on automatically once you set the alarm time.

ACTIVATING ALARM AND TEMPERATURE PRE-ALARM FUNCTION

1. In normal mode, press [ ALARM ] key to show the alarm time for 5 seconds.
2. When the alarm time displays, press [ ALARM ] key again to activate the alarm function. Or
press [ ALARM ] key twice to activate the alarm with ice pre-alarm function.
Alarm off
NOTE:
Once the ice pre-alert activates, the pre-set alarm will sound and ice-alert icon will flash 30
minutes earlier if the outdoor temperature is below -3°C.
When clock reach the alarm time, alarm sound will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in
the next day.
- By pressing [ALARM/SNOOZE] key to enter snooze that the alarm will sound again after 5
minutes.
- By pressing and hold [ALARM/SNOOZE] key for 2 seconds to stop the alarm and will activate
again in the next day
- By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day.
NOTE:
- The snooze could be used continuously in 24 hours.
- During the snooze, the alarm icon "
TEMPERATURE / HUMIDITY FUNCTION & TREND
Use the [ °C / °F ] slide switch to select the temperature display unit. The temperature /
humidity trend indicator shows the trends of changes in the forthcoming few minutes.
Arrow indicator
Temperature / Humidity trend
NOTE:
- When indoor temperature is below -40°C, the LCD will display "Lo". If temperature is above
70°C, LCD will display "HI".
- When outdoor temperature is below -40°C, the LCD will display "Lo". If temperature is above
80°C, LCD will display "HI".
- When humidity is below 1%, LCD will display "Lo". If humidity is above 99%, LCD will display
"HI".
] key to change the value. Press and hold the key for quick-adjust.
] key to adjust the value of the flashing digit.
" icon will display on the LCD.
" will keep flashing.
Alarm on
Rising
18
Alarm with ice-alert
Steady Falling