Barometric Pressure; Rainfall; Max / Min Data Record - Explore Scientific WSX1001 Manual De Instrucciones

BAROMETRIC PRESSURE

The atmospheric pressure is the pressure at any location of
the earth caused by the weight of the column of air above it.
One atmospheric pressure refers to the average pressure and
gradually decreases as altitude increases. Meteorologists use
barometers to measure atmospheric pressure. Since variation in
atmospheric pressure greatly affected by weather, it is possible
to forecast the weather by measuring the changes in pressure.
TO SET THE BAROMETER UNIT
In normal mode, press [ BARO UNIT ] key to change the barometer unit in this sequence: hPa
→ inHg → mmHg
TO VIEW THE ABSOLUTE / RELATIVE BAROMETRIC READING
In normal mode, press [ BARO ] key to switch between ABSOLUTE / RELATIVE barometric
reading.

RAINFALL

The RAINFALL section shows the rainfall and rain rate
information.
TO SET THE RAINFALL UNIT
1. Press and hold [ RAIN ] key for 2 seconds to enter unit setting mode.
2. Press [ ] or [ ] key to toggle the rainfall unit between mm and in.
3. Press [ RAIN ] key to confirm and exit the setting.
TO SELECT THE RAINFALL DISPLAY MODE
Press [ RAIN ] key to toggle between:
1. HOURLY - the total rainfall in the past hour
2. DAILY - the total rainfall from midnight
3. WEEKLY - the total rainfall of the current week
4. MONTHLY- the total rainfall of the current calendar month
5. Total - the total rainfall since the last reset
6. Rate - Current rainfall rate in past an hour (Update every 24 seconds)
TO RESET THE TOTAL RAINFALL RECORD
In normal mode, press and hold [ HISTORY ] key for 2 seconds to reset all the rainfall record.
NOTE:
To ensure correct data, please reset all the rainfall record when you reinstall your wireless 5-IN-
1 sensor to other location

MAX / MIN DATA RECORD

The console can record the accumulated MAX / MIN weather data with the corresponding time
stamp for you to easy review.
TO VIEW THE ACCUMULATED MAX / MIN
In normal mode, press [ MAX / MIN ] key to check MAX/MIN records. The display sequence is:
indoor (or current channel) MAX temperature indoor (or current channel) MIN temperature
indoor (or current channel) MAX humidity indoor (or current channel) MIN humidity
21