Publicidad
BLIND STITCH
06
SETTINGS :Presser foot - Blind Hem Foot
- Regular blind stitch for normal fabrics
- Elastic blind stitch for soft, stretchable fabrics
06
1. First finish the raw edge. Do this by turning it under on fine
fabrics or overcasting it on medium to heavyweight fabrics.
Then turn the hem up the required depth, press and pin in
place.
2. Now fold the fabric as illustrated.
3. Place the fabric under the foot. Turn the handwheel counter
clockwise (toward you) by hand until the needle swings fully
to the left. It should just pierce the fold of the fabric. If it does
not, adjust the guide (B) on the Blind hem Foot (A) so that
the needle just pierces the fabric fold and the guide just rests
against the fold.
NOTE: For a narrower or wider blind hem, first
manually adjust the length and width controls to
your desired length and width. Then adjust the
guide on the foot.
Sew slowly, guiding the fabric carefully along the edge of
the guide.
4. When completed, the stitching is almost invisible on the
right side of the fabric.
NOTE: It takes practice to sew blind hem. Always
make a sewing test first.
MULTI-STITCH ZIGZAG
SETTINGS :Presser foot - General Purpose Foot
This is a strong stitch because as its name implies, it makes
three short stitches where the normal zig-zag makes only one.
For this reason, it is recommended for overcasting most types
of fabrics.
It is also ideal for mending tears, applying patches and
inserting elastic.
42
Under side
Reverso
Envers
Under side
Reverso
Envers
07
2
1
Medium to heavyweight fabric
Material de peso medio a pesado
Tissus moyens et lourds
Under side
Reverso
Envers
1
2
Fine fabric
Material fino
Tissus fins
Under side
Reverso
Envers
3
4
Top side
Cara
Endroit
B
A
Publicidad
