22
HOW TO USE
Control Panel Features
* Depending on the model, some of the
following functions may not be available.
Vertical Display
Horizontal Display
LED Display Indicator
Control Button
LED Display
Indicator
Control
Button
Ice Type
Vertical Display
Select Crushed Ice or Cubed Ice by pressing the Ice
Type button repeatedly to choose the selection
desired. The Crushed Ice or Cubed Ice icon will
light up to indicate your selection.V
Selecting this icon indicates that cubed ice
will be dispensed when the dispenser pad
is activated.
Selecting this icon indicates that crushed
ice will be dispensed when the dispenser
pad is activated.
Horizontal Display
Select Crushed Ice, Cubed Ice or Water
by pressing the Dispenser button
repeatedly to choose the selection
desired. The Icon will light up to
indicate your selection.
To dispense water or ice, gently push your cup
against the dispenser pad (see page 26).
NOTE:
Hold your cup in place for a couple of
seconds after dispensing ice or water so the last
few drops go in y
Temperature
The Refrigerator Temp. Control ranges
from 33°F to 46°F (1°C to 8°C). Press the
Refrigerator button to cycle through
the available temperature settings one
increment at a time.
The Freezer Temp. Control range is from
-6°F to 8°F (-21°C to -13°C). Press the
Freezer button to cycle through the
available temperature settings one incre-
ment at a time.
NOTE: When changing control settings, wait 24
hours before making additional adjustments. The
controls are set correctly when milk or juice is
as cold as you would like and when ice cream is
rm. If the temperature in either compartment
is too cold or too warm, change the setting
one increment at a time. Wait 24 hours for the
change to stabilize before adjusting again.
Temperature Mode Switch Function
(°F <->°C)
If you want to convert °F to °C or vice versa,
press and hold the Freezer and Refrigerator
buttons at the same time for approximately
ve seconds. (Type 2 is not available)
r.