This User's Manual is applicable to a variety of
models and there may be slight changes in certain
aspects from model to model.
1. Illustration of Parts
1
Shelf (glass)
2
Interior light & thermostat
3
Top lid of crisper
4
Crisper
5
Freezer door
6
Freezer
7
Drip tray
8
Bottle rack
2. Environmental Protection and
Proper Disposal
Package materials
The appliance is packaged in a way to prevent damages
during transportation. Recyclable materials are used.
The packing box is made of corrugated board / cardboard
(mainly from recycled paper).
Polystyrene parts (CFC-free foamed polystyrene)
Linings and polyethylene bags
Polypropylene straps
All these valuable materials may be taken to a waste
collecting center and used again after adequate recycling.
All waste materials should be disposed properly.
All manuals and user guides at all-guides.com
9
Bottle rack (tall)
10
Lower
hinge
and
leveling leg
11
Condenser
12
Compressor
13
Ice tray
14
Lampshade
15
Lamp
16
Switch
2
3. Location
Make sure the refrigerator is kept upright during handling.
If an inclination is required, it should not exceed 45
degrees. Otherwise the appliance may get damaged
resulting
not
only
in
performance.
To avoid product damage or personal injury, the
refrigerator should be unpacked by two persons after it is
located in a previously selected position.
Before installation, make sure the refrigerator has no
visible exterior damage.
When handling the refrigerator, do not lift it by holding the
worktop, to prevent any damage to the refrigerator.
Do not start up a refrigerator that is damaged.
Check the refrigerator carefully for:
Damaged package due to inappropriate handling
during transportation
Damage in the exterior
Damage in power cord / plug
Any doubt, please contact Customer Service for a
thorough checkup of the appliance.
Take necessary measures to prevent leakage of
refrigerant at the start-up of refrigerator that may result in
environmental pollution.
4. Installation
a)
Remove all package materials.
b)
Remove items in the refrigerator.
c)
Make sure to remove film and tape on the cabinet
and the door.
d)
Remove polystyrene chips (if any) around the
refrigerator.
e)
Take out accessories and literature in the refrigerator.
f)
Clean the inside of the refrigerator with lukewarm
water and vinegar and then dry it with a soft cloth.
g)
Use the spanners supplied to adjust the leveling leg
to ensure the refrigerator is stable.
Do not use detergents, sharp or pointed instruments
or soda-based cleansers to clean the refrigerator.
Before installation, make sure the refrigeration system
is free of any damage.
The refrigerator should be used for its intended
purpose only.
The refrigerator should be positioned on the solid and
compromised
refrigeration