RIDGID HD1800 Manual Del Usuario página 7

ASSEMBLY
POWERHEAD ASSEMBLY (Fig. 7)
1. To Attach the Powerhead Assembly to Dust Drum:
Place Powerhead Assembly (A) on top of Dust Drum
(B) with the Extended Lip of the Lid aligned with the
Vac Inlet Port. Be sure Powerhead Assembly is fully
seated on the Dust Drum.
2. Press in on the Two Latches, located on either side
of the Dust Drum (B) until they snap into place,
securing the Powerhead Assembly to the Dust
Drum.
3. To Remove the Powerhead Assembly: Pull out on
the Two Latches and lift Powerhead Assembly (A)
from the Dust Drum (B). Do not force the Latches
to rotate more than slightly outside Drum flange.
(A)
Drum
Latch (2)
(B)
SP7051-1 ESF.indb 7 SP7051-1 ESF.indb 7
CARRY HANDLE/POWER CORD WRAP
ASSEMBLY (Fig. 8)
1. Locate the Carry Handle/Power Cord Wrap (N) and
Two #10 x 3/4" (19 mm) Pan Head Screws (F) in
loose parts bag.
2. Position the Carry Handle/Power Cord Wrap (N) on
top of the Powerhead Assembly (A), with the Carry
Handle/Power Cord Wrap Extended Flange to the
rear of the Powerhead Assembly, as shown.
3. Insert a #10 x 3/4" (19 mm) Pan Head Screw
(F) through the Hole at each end of the Carry
Handle/Power Cord Wrap and into the Powerhead
Assembly. Tighten securely.
Fig. 7
Extended Flange
(A)
Vac
Inlet
Port
HOSE STORAGE CLIP ASSEMBLY (Fig. 9)
1. Locate the Two Hose Storage Clips (O) and Four
#10 x 3/4" (19 mm) Pan Head Screws (F) in the
loose parts.
2. Place a Hose Storage Clip (O) into the recess next to
one of the latches on the Powerhead Assembly (A).
The curve of the Hose Clip (O) should face outward.
3. Insert a #10 x 3/4" (19 mm) Pan Head Screw (F)
into each mounting hole and tighten securely.
Repeat on the other side.
(F)
(O)
Recess (2)
Drum
Latch (2)
7
(F)
(F)
(N)
4/21/21 10:57 AM 4/21/21 10:57 AM
Fig. 8
Fig. 9