RIDGID HD1800 Manual Del Usuario página 8

ASSEMBLY
INSTALLING/REMOVING PUSH CART HANDLE
(Fig. 10)
1. To Install Handle: Slide the Push Cart Handle (P)
into the two Handle Holders found on the rear of the
Dust Drum (B).
2. Press down evenly on the Push Cart Handle (P)
until both sides are fully seated in the Handle
Holders. The Release Buttons should audibly snap
into the Locking Holes.
3. To Remove Handle: Grasp both sides of the Handle
just above the Handle Holders. Press in firmly on
the two Release Buttons using the index fingers
while pulling up on the Push Cart Handle (P). It may
help to place a foot on one of the rear feet to secure
the Vac.
INSTALL:
REMOVE:
SP7051-1 ESF.indb 8 SP7051-1 ESF.indb 8
Fig. 10
(P)
Locking Hole (2)
Handle Holder (2)
(B)
(P)
Release Button (2)
Handle Holder (2)
(B)
ATTACHING AND REMOVING VACUUM HOSE
(Fig. 11)
1. Locate the end of the Tug-A-Long Positive Locking
Hose with Dual-Flex (Q) and align it with the Vac
Inlet Port. Align the Hose Locking Tab with the Inlet
Ridges. Push the Hose end straight into the Vac
Inlet Port until the Hose Locking Tab fully engages
the Inlet Ridges.
2. To Remove Hose: Rotate the end of the Tug-A-
Long Positive Locking Hose with Dual-Flex (Q)
in either direction to release the Hose Locking Tab
from the Inlet Ridges. You may also press the Hose
Locking Tab and pull the Hose end straight out of
the Vac Inlet Port.
Hose Locking Tab
INSERT HOSE
8
Fig. 11
Inlet Ridges
Vac Inlet Port
(Q)
REMOVE HOSE
4/21/21 10:57 AM 4/21/21 10:57 AM