KTM 95812955044 Instrucciones De Montaje página 32

5 ASSEMBLY
5.2
12
501591-01
Assembling the shock absorber
501198-01
Info
After approx. half the oil capacity has been filled,
screw in the screw cover of the outside fork tube,
unclamp the fork and bounce a number of times so
that the cartridge fills with oil. Then add the remai-
ning amount.
–
Clamp the fork leg.
Clamping stand (T612S)
–
Grease the O-ring of the screw cap.
Lubricant (T158) (
–
6
Tighten screw cap
Guideline
Screw cap on the
outside fork tube
Ring wrench (T14091)
Final steps
–
Install the fork legs (see repair manual).
–
Install the front fender (see Owner's Manual/repair manual).
–
Remove the load from the rear of the vehicle.
–
Remove the motorcycle from the work stand at the rear (see
repair manual).
Preliminary work
–
Raise the motorcycle using a work stand at the rear (see repair
manual).
–
Remove the shock absorber (see repair manual).
Assembly
–
3
Install shock absorber
Final steps
–
Remove the motorcycle from the work stand at the rear (see
repair manual).
p. 15)
.
M47x1.5 40 Nm
(29.5 lbf ft)
(included) (see repair manual).