Makita HG6531C Manual De Instrucciones página 4

Icon Description
Reflector nozzle
Reduction nozzle
Wide-slot nozzle
Overlap welding nozzle
Solder sleeves reflector
Welding nozzle
Pressure roller
Scraper
Make sure that the tool is switched off and the nozzle has cooled down.
Q
Falling down nozzle may ignite objects on the floor. Nozzles must be mounted firmly and
Q
secure on the unit.
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle,
Q
allow the unit to cool down completely or use a suitable tool.
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
Q
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use
Q
only original nozzles according to the table that are suitable for your unit.
INSTRUCTIONS FOR USE
If you are not sure about the correct
setting, start with a low temperature
setting and gradually increase the
temperature until you achieve opti-
mum results.
Purpose
Soldering pipes
Welding, sleeve shrinking (heat concentrated over small area )
Drying, thawing (heat spread over wider area )
Welding
Soldering
Welding
Press the surface of working piece
Stripping paint and varnish
Always observe the safety instruc-
tions and applicable regulations.
Use only one hand to hold the tool,
do not place your other hand over the
air vents.(Fig. 1)
Do not use the holes on the tool
housing for the fall prevention pur-
pose at high location.
4 English