Home Decorators Collection 34545-HBUN Manual De Instrucciones página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
WARNING: Make sure power is off before attempting
installation.
□
Loosen the two canopy screws (AA) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (AA) in the round
holes.
AA
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (E) and the set screw
(GG) must be completely tightened.
□
Loosen the set screws (GG) in the downrod coupler until the inside
of the channel is clear of the screw tip.
□
Remove and save the lock pin (FF) on the end of the downrod (E).
□
Slide the ceiling canopy (C) onto the downrod (E) followed by the
coupling cover (F).
□
Attach the downrod (E) into the coupler until the lock pin (FF) can
be inserted through the hole in both the rod and coupler.
□
Insert the lock pin (FF) through the hole in the coupler and
downrod (E) then attach the hitch pin (EE) on the other side.
□
Tighten both set screws on the coupler.
2
Routing the wires
□
Route the wires exiting the top of the fan motor
assembly (G) into the coupling cover (F).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the
downrod (E) assembly.
B
AA
C
7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
E
F
G
C
E
F
EE
FF
G
GG