Publicidad
Idiomas disponibles
Idiomas disponibles
G
B
Power factor:
Power class:
Noise:
Application information:
1. Optimum temperature in operation: 5 - 40 °C.
2. Altitude:maximum 1000 m.
3. Optimum temperature for storage of the generator:
- 25 - 70 °C.
7. Before putting the generator into
operation
Remove the packaging material and check that all
items have been supplied. Place the generator on a
firm, flat surface near the electrical equipment and
ensure proper ventilation.
7.1 Electrical safety:
Electric supply cables and connected equipment must
•
be in perfect condition.
The generator is to be operated only with equipment
•
whose voltage specifications conform with the
generator's output voltage.
Never connect the generator to the power supply
•
(socket-outlet).
Keep the cable length to the electrical equipment as
•
short as possible.
7.2 Environmental protection
Dispose of soiled maintenance material and operating
•
materials at the appropriate collection point.
Recycle packaging material, metal and plastics.
•
7.3 Connecting to earth (Fig.2)
The housing is allowed to be connected to earth in
order to discharge static electricity. To do this, connect
one end of a cable to the earth connection on the
generator (Item 8) and the other end to an external earth
(for example an earthing rod).
7.4 Topping up fuel (Fig.1)
1,0
G1
WARNING
96 dB(A)
Switch off and ensure you are in a well ventilated area.
Unscrew the tank cover (Item 2) and add enough
unleaded gasoline using a filler neck.
Ensure that you do not overfill the tank and spill petrol.
(If you do spill, wipe up the excess amount and wait until
the vapors have evaporated – danger of ignition.) Screw
the tank cover back on.
7.5 Topping up oil (Figs. 3 , 6 and 7)
WARNING
Switch off and ensure you are in a well ventilated area.
Use for SIG 1100, SIG 2000
Open the oil filler screw (Item F) and add approximately
0,6 l of engine oil (15W40) using the supplied oil filler
jug (Item 19 and 20) or until the top fill mark on the oil
dipstick (Item D) is reached.
Use for SIG 3050
Remove the engine cover (Item 5) using the screwdriver.
Open the oil filler screw (Item F) and add approximately
0,6 l of engine oil (15W40) using the supplied oil filler
jug (Item 19 and 20) or until the top fill mark on the oil
dipstick (Item D) is reached.
Important:
Do not screw in the oil dipstick to check the oil level –
only insert it as far as the thread. Close the oil filler
opening and remount the engine cover.
Important! You must fill up with engine oil and fuel
before you can start the engine.
8. Operation
Check the fuel level and top it up if necessary.
•
Make sure that the generator has sufficient ventilation.
•
Make sure that the ignition cable is secured to the
•
16
Publicidad
