Teac A-H300mkIII Manual Del Usuario página 5

Remote Control Unit
The amplifier and Reference 300mkIII series connected by
remote control cords can be operated by the provided remote
control unit.
When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the A-H300mkIII.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there
are any obstacles between the unit and the remote control.
< If the remote control unit is operated near other appliances
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other appliances may
operate incorrectly.
Battery Installation
1 Remove the battery compartment cover.
2
Insert two "AAA" (R03, UM-4) dry batteries. Make sure that
the batteries are inserted with their positive "+" and negative
"_" poles positioned correctly.
3
Close the cover.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they leak,
wipe away the liquid inside the battery compartment and
replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
System Connection
Reference 300mkIII
If you have TEAC Reference 300mkIII series, convenient
system control operations and AI direct play functions are
possible.
< By pressing the STANDBY/ON button of A-H300mkIII, you can
switch ON/standby all the unit connected by remote control
cords.
< When you press the PLAY button of a source, the INPUT
SELECTOR of A-H300mkIII is set to the source automatically.
< The source you select by the INPUT SELECTOR of A-H300mkIII
will be played automatically.
< When you turn on the system, the source that was selected
last time will start playback automatically.
< You can use the system remote control unit to operate all the
unit connected by remote control cords.
Connect the REMOTE CONTROL jack (A or B) of each
component by remote control cords.
A-H300mIII
Reference300mkIII
REMOTE
CONTROL
Reference300mkIII
REMOTE
CONTROL
Dubbing
When you intend to dub a cassette tape using 2 sets of R-
H300mkII, don't connect the remote control cords to the
second deck. Please use the buttons on the front panel.
5