Sharp FU-55SE Manual De Uso página 9

PREPARATION
INSERTING BATTERIES IN THE REMOTE CONTROL
USING THE REMOTE CONTROL
• Operate the remote control facing the main unit
(Receiver).
• The signal range is about 7m (front).
• Make sure there are no objects blocking the path
of the signal.
• A void strong impact on the remote control. In addition, do not wet the remote control or
place it under direct sunlight or near a stove, etc., otherwise a malfunction may occur.
FU-55SE_Eng.6.5
Downloaded from: http://www.usersmanualguide.com/
• The battery life is about 1 year.
• Replace the batteries when the remote control becomes inoperative.
• Incorrect usage of the batteries may cause battery fluid leakage and/or
damage. Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones
of the same type. (Use R6(AA) manganese batteries (2 units).)
• When not using the unit or remote control for an extended period,
remove the batteries. This prevents malfunction of the remote control
from battery fluid leakage.
*The batteries of the accessory are for initial use only and may be
depleted within 1 year.
NOTE
7
1
Remove the back cover
Press and slide the back cover to re-
move.
2
Insert batteries
Insert batteries with
shown below.
3
Close the back cover
About the batteries
Receiver
E-7
03.7.17, 8:53 AM
and as
Transmitter