Descargar Imprimir esta página

LG DLEX4500 Serie Manual Del Propietário página 28

Ocultar thumbs Ver también para DLEX4500 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Three-Wire Power Cord
• A 3-wire connection is NOT permitted
on new construction after January 1,
1996.
• A UL-listed strain relief is required.
• Use a 30-amp, 240-volt, 3-wire,
UL-listed power cord with #10 AWG-
minimum copper conductor and closed
loop or forked terminals with upturned
ends.
1
Remove the terminal block access cover on the
upper back of the dryer.
2
Install a UL-listed strain relief into the power
cord through-hole.
3
Thread a 30-amp, 240-volt, 3-wire, UL-listed
power cord with #10 AWG-minimum copper
conductor through the strain relief.
UL-Listed 3-Wire Power
Cord
4
Attach the two hot leads (black and red) of the
power cord to the outer terminal block screws.
5
Attach the neutral (white) wire to the center
terminal block screw.
6
Connect the external ground (if required by local
codes) to the green ground screw.
7
Tighten all screws securely.
8
White Wire from Dryer
harness
Terminal Block
UL-Listed Strain Relief
Reinstall the terminal block access cover.
Hot (Black)
Ground Screw
External Ground Wire (If
required by local codes)
27
INSTALLATION
Neutral (White)
Hot (Red)

Publicidad

loading

Este manual también es adecuado para:

Dlgx4501 serieDlex4500b