Publicidad
Idiomas disponibles
Idiomas disponibles
NON-DUCTED FILTERS
If hood is to be installed Non-Ducted:
Purchase a set of (2) Non-Ducted Filters from your local
distributor or retailer and attach them to the aluminum mesh
filters.
NOTE: For models that are installed in the non-ducted mode,
the most effective operation is achieved at speeds 1 and
2. These speeds provide the most efficient and quiet
operation during cooking, while maximizing the benefits
of the recirculating filtration system.
OPERATION
Always turn the hood ON before cooking in order to establish an air
flow in the kitchen. After turning off the range, let the hood run for a
few minutes to clear the air.
This range hood is equipped with the latest in capacitive touch tech-
nology. The buttons do not move, but are touch sensitive. When a
touch is understood, the control will emit a sound.
1. Touch any button to "wake up" the control.
FAN
2. Touch fan button to turn fan on to low speed.
3. Touch fan button again for medium speed, high
speed, and fan off.
The graduations under the fan icon in the LCD screen will
illuminate to indicate the current fan speed setting.
LIGHT
2. Touch light button to turn light on to dim setting.
3. Touch light button again for medium, bright, and
light off.
The graduations under the light icon in the LCD screen
will illuminate to indicate the current light intensity setting.
DELAY OFF
This feature allows the fan to run for 10 minutes, then
automatically shut the fan off. Use this feature to clear the
air after you are finished cooking.
1. While fan is operating, touch the delay off button.
The button will flash while the delay off feature is
active.
FILTER CLEAN
The filter clean reminder will flash when it is time to clean
or replace the filter, based on your individual use pattern.
To reset filter clean reminder indicator, touch and hold
button for three seconds.
HEAT SENTRY
The heat sentry continuously monitors temperature and will
automatically turn the fan on to high speed when the temperature
is above normal.
The fan button will flash while the heat sentry is active.
After the temperature returns to normal, the heat sentry will return
the fan to it's previous setting.
NOTE:
This hood utilizes an offset blower design to achieve greater
performance and lower sound levels. As a result, you may notice
that cooking impurities are more attracted to one side or appear
to be pulled-in faster than they appear on the opposite side. This
is completely normal. The hood has been designed and tested
to provide good capture of cooking impurities and odors under
all normal cooking conditions regardless of the cooking location
on the cooktop. Please note that cooking on the rear burners
will always result in the best capture results, regardless of the
hood design.
CLEANING & MAINTENANCE
WARNING: To reduce the risk of electric shock, discon-
nect from power supply before cleaning.
Aluminum mesh filters: Clean frequently using hot water and a
mild detergent. Filters are dishwasher safe.
Charcoal filters: Clean filter surfaces frequently with a damp cloth
and a mild detergent. DO NOT immerse filters in water or put in dish-
washer. The special "Clean Sense" feature indicates when the filter
is to be replaced. The dotted lines on the indicator strip will change
to solid wide lines when it is time to change the filter. The "Clean
Sense" feature works best when facing toward the cooking surface.
To clean hood: Remove filters. Use a damp cloth and a mild deter-
gent to wipe all grease-laden surfaces. Do not use abrasive cloth,
steel wool pads, or scouring powder on the Teflon
cover or on any painted surface. Use care when cleaning blower
wheel - it must not become bent or misaligned. DO NOT ALLOW
WATER TO ENTER MOTOR. Make sure all surfaces are completely
dry before re-installing filters and restoring power.
Motor is permanently lubricated. Do not oil or disassemble motor.
Teflon
is a registered trademark of DuPont.
®
CJD3 SERIES
Page 6
®
-coated bottom
Publicidad
