Publicidad
Idiomas disponibles
Idiomas disponibles
en
18
Switching on and off (figure 10).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
When the power supply is disconnected
while the motor is running or when the
switched-on power tool is plugged in, the
motor will not restart.
When the application tool continuously
blocks or is subject to overload, the motor
stops automatically. Restart the motor again.
For stationary use in a drill stand, remove the
switched off power tool from the drill stand
at operating temperature every 50 operating
hours and turn it by 180° to achieve uniform
lubrication.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Locking on:
Press the On/Off switch to the stop and press
in the Locking button.
Release the On/Off switch.
For switching off, briefly press the On/Off
switch until the Locking button disengages.
Release the On/Off switch.
Publicidad
