Nolan N40-5GT Seguridad E Instrucciones página 13

N40-5GT
16.6. Push the padding of the cheek pad in line with the snap fastener on its back
by fastening it to the attachment seat of the frame fixed to the shell (Fig. 19).
Whilst doing this, check that the above mentioned rectangular textile exten-
sions do not come between the snap fastener and the corresponding fastening
seats.
WARNING
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet before completely and correctly reassembling its inner com-
fort padding.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner components with a damp cloth only and allow it to dry at room
temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
WIND PROTECTOR
(Available as standard or accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 24 for assembly and disassembly.
VENTILATION SYSTEM
The ventilation system of the N40 GT helmet consists of:
5
Front Air Intake:
the innovative AIRBOOSTER TECHNOLOGY channels the air coming from the front
air intake by directing it in the top area of the rider's head without any dispersion. The
front air intake (Fig. 25) can be completely or partially opened depending on whether
its slider is pulled completely backwards (A). To close the front air intake, pull the above
mentioned slider completely forward (B).
Chin guard air intake:
allows ventilation in the mouth and visor area. See Fig. 26 for how to open and close it.
Rear Extractors:
are integrated in a rear spoiler and allow warm and stale air to flow out ensuring an
optimum comfort inside the helmet. (Fig. 27).
24
INSTRUCTIONS FOR USE
N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
Your helmet is factory-preset to be equipped with the N-Com communication system.
If your helmet is homologated according to ECE/UN Regulation No.22, it has also been
tested and homologated with the N-Com system installed. Installing a system other
than the N-Com affects the helmet's regulatory compliance.
During the communication system installation (see the specific instructions contained
in the N-Com kit), it will be necessary to remove from the helmet the foam material fillers
located in the polystyrene cheek pads next to the N-Com earphones seats.
The above-mentioned fillers should only be removed if the helmet is used with a
compatible N-Com system installed.
N40-5GT
25
INSTRUCTIONS FOR USE