Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
ed and must be replaced. Only use an
original battery purchased from custom-
er service.
• Always comply with the latest safety
information, as well as the regulations
and information relating to environmen-
tal protection.
• Defects resulting from improper han-
dling are not covered by the guaran-
tee.
Charging the battery
The lawn mower automatically returns to
the charging station when it has a low
charge status. To do so, the lawn mower
locates the nearest boundary wire and fol-
lows this in a clockwise direction.
You can also place the lawn mower
in the charging station yourself.
Risk of injury! Press the STOP button
(9) before picking up the mower!
After the battery is fully charged, the
charging process stops and the lawn mow-
er switches to standby mode.
Graphical symbols on the charging
station
LED illuminated red:
Battery charging
LED illuminated green:
Battery charged
LED not illuminated: Charging station not
connected to power
62
LED fl ashing green:
Boundary wire dam-
aged or incorrectly
connected
Checking the charge level of
the battery
You can check the charge status of the
lawn mower on the display at any time.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. The charge status is now shown by the
battery symbol at the top right.
4. Press the START button (3) and close
the cover (1) again. The lawn mower
resumes its previously interrupted activi-
ty.
It is also possible to read the charge
level without unlocking the display,
but it is easier when the display is un-
locked.
Working instructions
Regular mowing stimulates the grass to an
increased leaf formation, while at the same
time killing weeds. As a result, the lawn
becomes denser after each mowing and
an evenly resilient lawn is created.
The fi rst cut takes place roughly in April
when the grass is about 7 - 8 cm high. Dur-
ing the main growing season, the lawn is
mowed at least once a week.
Setting the cutting height
Switch off the device and wait for
the blades to come to a stop. There
is a risk of personal injury.
1. Open the cover (1).
2. Set the rotary wheel (2) to the desired
cutting height.
3. Close the cover (1) again.
Publicidad
