Descargar Imprimir esta página

Beko WTV 6501 BS0S Manual Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Remove transportation safety bolts by turning
them gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)
C
NOTE :
Keep the transportation safety bolts in
a safe place to reuse when the washing machine
needs to be moved again in the future.
NOTE :
Never move the product without the
transportation safety bolts properly fixed in place!
2.4 Connecting water supply
C
NOTE :
The water supply pressure required to
run the product is between 1 to 10 bars (0.1 – 1
MPa). It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in one
minute to have your machine run smoothly.
Attach a pressure reducing valve if water
pressure is higher.
NOTE :
If you are going to use the double water-
inlet product as a single
you must install the supplied stopper to the
hot water valve before operating the product.
(Applies for the products supplied with a blind
stopper group.)
A
WARNING:
Models with a single water inlet
should not be connected to the hot water tap. In
such a case the laundry will get damaged or the
product will switch to protection mode and will
not operate.
WARNING:
Do not use old or used water inlet
hoses on the new product. It may cause stains on
your laundry.
7 / EN
(cold)
water-inlet unit,
1. Connect the special hoses supplied with the
product to the water inlets on the product. Red
hose (left) (max. 90 ºC) is for hot water inlet, blue
hose (right) (max. 25 ºC) is for cold water inlet.
A
CAUTION:
Ensure that the cold and hot water
connections are made correctly when installing
the product. Otherwise, your laundry will come
out hot at the end of the washing process and
wear out.
2. Tighten all hose nuts by hand. Never use a tool
when tightening the nuts.
3. Open the taps completely after making the
hose connection to check for water leaks at the
connection points. If any leaks occur, turn off
the tap and remove the nut. Retighten the nut
carefully after checking the seal. To prevent water
leakages and damages caused by them, keep the
taps closed when the machine is not in use.
Washing Machine / User's Manual

Publicidad

loading