Publicidad
Idiomas disponibles
Idiomas disponibles
2.5 Connecting to the drain
• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A
CAUTION:
Your house will be flooded if the
hose comes out of its housing during water
discharge. Moreover, there is risk of scalding due
to high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of the
discharge hose tightly so that it cannot come
out.
• The hose should be attached to a height of at least
40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on the
floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not be bent, it should
not be stepped on and the hose must not be
pinched between the drain and the machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of
the hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between the
extension hose and the drain hose of the product
must be fitted well with an appropriate clamp as
not to come off and leak.
8 / EN
2.6 Adjusting the feet
A
CAUTION:
In order to ensure that the product
operates more silently and vibration-free,
it must stand level and balanced on its feet.
Balance the machine by adjusting the feet.
Otherwise, the product may move from its place
and cause crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
WARNING:
Do not use any tools to loosen the
lock nuts. Otherwise, they will get damaged.
2.7 Electrical connection
Connect the product to a grounded outlet protected
by a 16 A fuse. Our company shall not be liable for
any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after
installation.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables or
multi-plugs.
B
DANGER:
Damaged power cables must be
replaced by the Authorized Service Agents.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the product.
4. Install transportation safety bolts in the reverse
order of removal procedure;
C
NOTE :
Never move the product without the
transportation safety bolts properly fixed in
place!
Washing Machine / User's Manual
Publicidad
