Vollrath TS17001 Manual De Instrucciones página 3

OPERATION
Burn Hazard.
Do not touch cookware, heating surface, food,
or liquid while heating nor allow skin to come
into close contact with steam.
Allow hot surfaces to cool before handling or cleaning. Do not
allow water to contact the cooking surface; splattering or spraying
could occur.
Electrical Shock Hazard.
Keep liquids from entering the unit; this could
cause a short circuit or electrical shock. Do
not spray the unit, cord, plug, or immerse the
unit or components in liquid or foam.
1. Turn unit on with Power Switch.
2. Close top grill plate. Set thermostat to desired temperature.
Ready Light glows when set temperature is reached.
3. Open the top plate and center food on the bottom plate.
4. Use the handle to lower the Top Grill Plate.
5. Heat for the desired length of time.
6. Raise the handle and remove the food.
7. After cooking, wipe down grill plates to remove fat, oil, and
grease — and prevent carbon build-up.
WARNING
WARNING
Panini Sandwich Grills
CLEANING / MAINTENANCE
Burn Hazard.
Do not touch cookware, heating surface, food,
or liquid while heating nor allow skin to come
into close contact with steam.
Allow hot surfaces to cool before handling or cleaning. Do not
allow water to contact the cooking surface; splattering or spraying
could occur.
Electrical Shock Hazard.
Keep liquids from entering the unit; this could
cause a short circuit or electrical shock. Do
not spray the unit, cord, plug, or immerse the
unit or components in liquid or foam.
Cleaning

N OTICE: Do not clean the unit with steel wool.
To maintain appearance and increase service life, clean unit daily.
1. Turn unit off with the Power Switch.
2. Unplug unit and allow it to cool completely.
3. Wipe grease or oil into the drip tray.
4. Cast-iron models only — use included brush to scrub grill
plates.
5. Dip a cloth or sponge in soapy water and wipe unit and
plates.
6. Rinse and dry thoroughly.
7. Cast-iron models only — if necessary, season plates per
Unpacking and Initial Setup.
8. Empty and clean the drip tray.
Maintenance
In time, the Top Grill plate will lower due to wear on the
Tensioner. To adjust:
1. Turn Power Switch off and allow unit to cool completely.
2. Remove silicone Tensioner Plugs (I) from screw holes.
3. While testing Top Griddle Plate movement, adjust Tensioner
Screws with an M5 Allen wrench until desired tension is
reached.
4. Replace Tensioner Plugs by pushing them back into screw
holes.
WARNING
WARNING
3