GreenWorks Pro MO80L410 Manual Del Operador página 10

EN
7.8 INSTALL THE BATTERY PACK
24
26
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
The machine has a battery storage compartment that helps
store the battery pack.
1. Open the battery door(5).
2. Align the lift ribs on the battery pack(24) with the
grooves in the battery compartment.
3. Push the battery pack(24) into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The engine starts only when you put in the safety key(26).
7.9 REMOVE THE BATTERY PACK
1. Open the battery door(5).
2. Remove the safety key(26).
3. Push and hold the battery release button(25).
4. Remove the battery pack(24) from the machine.
8 OPERATION
Wear eye protection during operation.
5
25
WARNING
NOTE
NOTE
WARNING
English
8.1 START THE MACHINE
1
2
1. Put in the safety key.
2. Push and hold the start button(2).
3. While you hold the start button(2), pull the bail switch(1)
in the direction of the handle bar.
4. Once the machine has started you can release the start
button(2).
8.2 STOP THE MACHINE
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
8.3 OPERATE THE SELF-PROPEL
SYSTEM
The machine is built with a thermal protector to stop the
self-propelled motor when overload occurs. It's a device
calibrated to open the self-propelled motor circuit upon
reaching a certain temperature/current. Re-setting the
protector requires both cool down below the calibration
point and removal of power supply. When the protection
happens, the operator should release the self-propel bail
lever (10) immediately ,then restart self-propel operation
after at least 30 minutes.
10
WARNING
WARNING
NOTE