Lenco KCR-100SI Manual De Usuario página 6

FRONT PANEL
1. STANDBY /SOURCE
Press to turn on the unit. When it is turned on, press this button will toggle between FM and Bluetooth mode. Press and hold to
turn off and go to Standby mode
2. LIGHT ON/OFF
Slide to turn on or turn off the downward lighting
3. NUMERIC BUTTONS
Press to direct tune to the stored preset FM channel
4. DISPLAY
5. SCAN/ST-MONO/PAIRING
FM: Press to toggle between FM Stereo and Force Mono reception. Press and hold to start the full auto-scanning and store the
available FM channels
BT: Press and hold to disconnect the current connection and start to search another new Bluetooth device
6. /MIN.
FM: Press to tune to a different frequency. Press and hold to auto-scan to the next available channel
BT: Press to skip to the previous track
Timer Setup: Press to setup the minute setting
7. /SEC.
FM: Press to tune to different frequency. Press and hold to auto-scan the next available channel
BT: Press to skip to the next track
Timer Setup: Press to setup the second setting
8. /CLOCK SET/MEMORY
FM: Press to tune to different stored preset FM channel. Press and hold to store the preset FM channel as desired
BT: Press to toggle between pause and resume playback operation
Standby mode: Press to enter the clock setup operation
9. TIMER
Press to enter the Timer Setup
10. – VOLUME +
Adjust the volume control
11. FM Freqency 0.05MHz LED
When the FM frequency of 0.05MHz is received, this LED will turn on. For example when 88.15MHz is received, the display will
show "88.1" and this LED will turn on
12. BT LED
It is an indicator and turn on when it is in Bluetooth mode
13. FM LED
It is an indicator and turn on when it is in FM mode
14. FM-ST LED
It is an indicator and turn on when it is in FM Stereo mode
15. PM LED
It is an indicator and turn on when it is in 12 hours display format at afternoon time
6