ims PRO SPOT TRAFO 14500 Manual página 47

Specific Installation for C2 and C8 arms
For these arms, the Stretches will also need to be changed. Unscrew the short stretches with a flat
spanner and remove the injector. Centre the injector along the axle of the clamp (Caution: beveled side outside) and insert it manually(1)
Position the long stretches in front and screw it on to the clamp axle (maximum torque 15Nm) (2).
Short Stretches
Long Stretches
Stretches types:
Short: C1, C3, C4, C5, C6, C7, C9, C10, C12, C14
Long: C2, C8
ADJUSTMENT OF C ARMS
SPOT TRAFO 14500
- Disconnect the cooling liquid pipes and unlock the lever.
- Remove the clamp arm.
- Lubricate both a new arm and the support with contact grease (ref.050440).
Short Injector
Long Injector
1
3
4
2
- Lower the locking knob which allows over-opening.
1
- Pull out the adjustment knob
on the pin .
3
- Tighten the toothed ring by hand and then turn the
4
adjustment knob so that returns to its seat and pre-
2
vents the toothed ring from turning.
EN
and turn it so that it rests
2
47