Publicidad
Idiomas disponibles
Idiomas disponibles
Tensioning the rewind spring
N
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
N
Hold the rotor steady. Pull out and
straighten the twisted rope.
N
Let go of the rotor.
N
Release the rope slowly so that it
winds onto the rotor. The starter grip
must locate firmly in the rope
bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
N
When the starter rope is fully
extended it must still be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of the rope off the
rotor.
KM 110 R, KM 130 R
N
Fit the starter cover on the housing.
N
Tighten down the screws firmly.
Storing the Machine
For periods of 3 months or longer
N
Drain and clean the fuel tank in a
well ventilated area.
N
Dispose of fuel properly in
accordance with local
environmental requirements.
N
Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N
Remove, clean and inspect the
working tool.
N
Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
English
25
Publicidad
